12/27/2023 0 Comments Repair mosin stock crackI do not expect it to split again in these areas. Tman then used a Dremel tool to grind them flush with the stock. We let these dry and then sawed them off close to the stock with a hacksaw. We placed two screws in the most critical places. I then filled the holes with the epoxy and covered the threads of the screws with the epoxy and screwed them into place. You don't want the screw holes to be too tight, as that would only encourage more splitting problems. I used the drill press to drill a couple of holes through the areas of the stock that had split. We went to a hardware store and bought a couple of course threaded brass screws. This is not a problem with these rifles, as mine already had several in the stock from past reworks at the factory that the Brits called FTR or Factory Thorough Repairs. We decided to also put a little insurance on the job, by adding a couple of Ishapore Indian brass screws through the stock. It would have to be sanded, but that didn't bother me. I then closed it up and used woodworking clamps to clamp it tight. I then used a toothpick to work it into the crack, which I held open with a screwdriver.Īnd here. I started by mixing up a two-part epoxy that I have used before with excellent results. We decided that we didn't have anything to lose and went to work. We looked at what it would cost to buy a replacement stock, but in the meantime, I looked at the possibility of repairing the stock. I really hated to see the crack as this had been a very nice example of a Lithgow SMLE and now it was unshootable. It had never even shown a warning, but a crack about 1/4 inch wide now ran from the rear of the fore stock to up past the trigger guard, about 9 inches long. I fired a few magazines full and laid it on the bench. Here's a picture of it from a couple of years ago.Īs you can see, the wood didn't match too well, but the metal was sound and it shot well. Last week we were shooting some C&R weapons.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |